Free Project for the ClayMill Extruder – Part II
As promised at the very bottom of my earlier posting, here is the project for the ClayMill extruder, entitled “Cat’s Eye Ladder.” To view or download the project as a PDF document, click here.
Because of differing conditions, tools, and individual skills, the author cannot be responsible for any loss, injury, or other damage that may result from the use of the information in this blog.
Copyright © 2013 Hadar Jacobson. All rights reserved. Hadar's Clay™ is a trademark of Hadar Jacobson. The terms "bronze clay" and "copper clay" are used generically and do not denote any particular product or brand.
Copyright © 2013 Hadar Jacobson. All rights reserved. Hadar's Clay™ is a trademark of Hadar Jacobson. The terms "bronze clay" and "copper clay" are used generically and do not denote any particular product or brand.
WordPress Theme by Michael Tyson.
January 9th, 2013 at 3:03 pm
Thank you so much.
January 9th, 2013 at 4:18 pm
Where does one purchase a clay ill extruder and what is its cost?
Thanks for the great lesson.
January 9th, 2013 at 4:22 pm
Oops, never mind…I just went back to look at your earlier posting and found the answers to my questions.
January 9th, 2013 at 5:10 pm
Hadar, how are you? I would like to look at the items we can make with the extruder before I order it. I tried to open this blog but nothing happened.
Thanks.
Michelle
January 9th, 2013 at 6:10 pm
Hi, Michelle. This document is a PDF file (like my Instruction Manual, Teaching Schedule, etc.). To view it, you will need Adobe Reader or similar software, which can be downloaded free of charge from get.adobe.com/reader. Simply click on the word “here” (the very last word of my posting above) to view the document.
If you already have PDF software on your computer and the document does not open, your browser may simply be storing the document to your hard drive when you click on the link. If you would like to save the file to a specific spot on your hard drive so you can open and view it later, right click on the link marked by the word “here” (the very last word of my blog posting above), and select “Save Link As…” or “Save Target As…”
January 9th, 2013 at 8:53 pm
That is a great project. I will see you this weekend for class. I hope we get to use one.
January 10th, 2013 at 3:15 pm
Hi, Hadar!
Hope all is well with you. Sounds like you are busy…as always! Thanks for pushing to get the large extruder. I’m eager to give it a try!
January 10th, 2013 at 9:41 pm
Thank you Hadar. You’re on my resolution list: “must take class with Hadar”. You’re a wonderful artist and human being.